When the water coming out of the taps in the home doesn’t smell good, there might be a problem with your hot water heater. There might be a few various reasons for smelly water, yet the leading cause is bacteria. If perhaps bacteria is entering into the water, an odor will more than likely develop. Well water is usually to blame for this occurring. However, there are some actions a Fort Lauderdale homeowner can take to prevent bacteria from developing in their water and to get rid of existing bacteria and smells.

According to Soquel Creek Water District, “The smell is the result of four factors that must all be present for the odor to develop. These factors include:

  • A high concentration of sulfate in the raw water
  • Sulfate reducing bacteria, non-toxic to humans (sulfate is reduced to a sulfide state by the bacteria)
  • Little or no dissolved oxygen in the water
  • Hydrogen (a component of water which may be present due to water conditions reacting with the anode)”  Read more here…

Stopping Water Heater Bacteria Growth

The best way to prevent bacteria from developing and bringing about bad tastes and smells throughout one’s property, is to be certain the temperature is fixed at 140 degrees or higher on one’s hot water heater. At this temperature bacteria are not able to grow and will die. Whenever your water heater temperature is placed below this, bacteria will not only exist but will grow.

Removing Hot Water Heater BacteriaEliminating Fort Lauderdale Water Heater Odors

In order to remove active bacteria and smells, one will have to apply harsh chemicals to destroy it. Chlorine bleach is the most efficient and complete chemical cleaner to utilize. If perhaps you are attempting to clean the water and eliminate the bacteria by using bleach yourself, be sure to fully understand the exact method of to do so. First of all, the electric or gas going to the water heater has to be switched off. After that the cold water supply will have to be switched off. Then, you will have to turn on one of the hot water taps within the house. This allows air into the tank. Using a garden hose, empty the water from the hot water heater and shut the drain valve once all of the water has been drained. After that, it is time to pour in the bleach. One will need five ounces of chlorine bleach for every gallon of water the tank holds. Unscrew the flexible cold water hose and pour the bleach into the opening. In case the cold water hose isn’t flexible, it could be a wise decision to get in touch with a specialist. Hook up the water line once again and refill the tank with water. It’s crucial to turn off the hot water faucet in the home as soon as all the air is out of the line. It’s likewise vital to run each one of the faucets which employ hot water in the property until you are able to smell the bleach. The bacteria which is in the water heater might also be in water lines and taps therefore you should eliminate the bacteria in these areas as well. Let the bleach water sit inside the tank and in the water lines for nearly 3 hours not having using any hot water. And then one more flush is due. Once the tank is drained for a second time, do not add more bleach but fill up with water and allow it to sit in the tank and inside the piping for no less than thirty minutes. Finally, drain the water just as before and refill the tank with water. Allow all the hot water appliances in the house drain until you can no longer smell bleach. Either turn the power on again or relight the pilot light and you should be good to go!

For any questions about water stench, flushing a water heater, Fort Lauderdale water heater repairs, or any other water heater concerns, call us!